Answer Posted / kamrul haque

Vibration Sensor are NPN transistor so they can give negative voltage only so they are set -10 v only.its because transistor works linear in -2 to -18v so -2 to-10 8 volts same in -10 to -18 so it can measure both away and near distnce.

selection criteria of control valve? and selection criteria of actuator explain in brief?

4125

---

hi! i want to know about mpse exam.

2353

---

Isometric drawings are generated during _________________ phase of a project

2124

---

Draw symbols of the following :

2030

---

How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?

2396

---

what is sliding spool valves?

2291

---

A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer

2728

---

Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?

2364

---

hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com

2613

---

what is the input of digital counter during the the calibration time?

2374

---

How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?

2086

---

please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?

2316

---

can you send remote seal interface level transmitter calculation steps for oil water saperator.

2670

---

Which products are available in the Mass Systemswitch and System Manager AC range?

1908

---

What is the basic difference between Modbus and CAN Open Protocols

6497

---