what is preventive maintenance , explain with difination
Answer Posted / dhananjayk
following meanings:
The care and servicing by personnel for the purpose of maintaining equipment and facilities in satisfactory operating condition by providing for systematic inspection, detection, and correction of incipient failures either before they occur or before they develop into major defects.
Maintenance, including tests, measurements, adjustments, and parts replacement, performed specifically to prevent faults from occurring.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
defination of radial vibration?
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
what is the responsibility of an instrument commissioning supervisor
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
how to relay switch sense the fault?
why we take %i0.0 as input for twido plc
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
Describe the function of Accumulator into the Pump
What are the types of valves?