Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / laxman
The nature of the generator it converts mechanical energy to electrical output(AC). by providing the commutator to the AC generator it comes out DC.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
derive DC RMS value for half wave rectifier?
What is shutdown of electrical sub station?
What is the basic principle of welding process?
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
trasnfarmaer core make
which VFD is better ( LT or HT)
List the disadvantages of constant k filters?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
what is meant by carrier aided trip protection in transmission line
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
