Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gopal krishna
there are many control valves.but the most interesting control valve is pneumatic control valve as there will be i/p converter in control valve which takes the signal from plc i.e(4-20ma)and corresponding value of air will be used to operate the stem.now the stem position is taken feedback by positioner in control valve and checks it with the setpoint value.if matches its ok if not gives the compensating signal
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calibrate Necleuonic level transmitter.?
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
Explain an adaptive / self-tuning controller’s major draw card.
what is temperature compensation?
Describe a time when you anticipated potential problems and developed preventive measures.
What is zener diode? What is voltage regulator?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
What is the procedure of calibration of Load cell?
How is flow measured in square root?
it is possible to check the fail safe condition in pressure transmitter. if possible how?
what is the difference between profibus and controlnet networking.
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
