how can we convert 48V dc into 12 V dc? Any standard device
for it??
- 2 Answers
- 4395 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramachandran
Buck converter is used
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how can we select the appropriate VCB ?
why high speed tripping relay is used in protection circuit why not normal relay
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
how to flameproof electrical motor on the shaft?
How to find ampere on ht side for selection of cable size ???
how ct burden,magnetising current,ratio and knee point voltage are related & derived
block diagram of 2 ups system connected in hot stand by mode?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What is the capacitance values of 132,220,400 & 765 kV current transformer
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
define reflection method?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
what is the circutor?why we use it ?
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
