Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between neutral and ground wire?
- 2 Answers
- 5235 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / mk
In Three phase supply ,phases are 120 deg appart and act as ref against each other .for single phase application, neutral which is commen point of phases is ref.ref is essential.ground pt is for safety where leakage current if any will pass to gnd.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Difference between RCCB, RCBO and ELMCB.
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
In radial network the source is fed from 1 end both ends at central
how we can calcultae the short circuit level for bus bar
What is the approximate value of stacking factor?
Is there any guideline say about display of earthing value near to earth pit
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
explanation of mesh bus bars
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
