how the 2.5bar pressure able to control the 40bar steam
- 8 Answers
- 9360 Views
- IBM, PAFL, Thirumalai Chemicals, I also Faced
- E-Mail Answers
Answer Posted / r_vaya
That's why in high pressures line(like super heater's steam in power plant) having double seated globe valves.therefor double seated plugs has line pressure both side equal (upside same and down side same ) is equal to line pressure 0
So thus, plug will operate according valve's pressure.....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How u measure the massflow in orifice flow measurement techniques
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
Give Detail information about plc,dcs,and scada system?
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
Please any one can provide latest aptitude test,technical test and interview questions for tata consulting engineering (TCE) i need it asap thanks in advance
What is force balance principle?
what is the process to make control schematic ?
what is droop in governer ,type of droop ,how it work
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
what is piezoelectric transducer?give an example in power plant n state its principle?
What is the use of temperature compensation?
