Interested to Buy Any Domain ? << Click Here >> for more details...
what should be distance from tapping point to inallation place of instruments?
- 3 Answers
- 6477 Views
- Tasnee Petrochemicals, I also Faced
- E-Mail Answers
Answer Posted / afsar mumtaz
D AND D/2 IN CASE OF UP STREAM AND DOWN STREAM
D: DIAMETER OF PIPE
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
What materials are used in thermo wells?
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Why do you want to work here
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
What is offset in a control system.
why I need valve guard and whats different between guard and positioner ??
Explain the working principle of lvdt?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
what are the steps I have to deal with?
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
how do we commission inergen system?
