Interested to Buy Any Domain ? << Click Here >> for more details...
why we use bare wire in high tension power instead of using insulated wire?
- 2 Answers
- 7428 Views
- I also Faced
- E-Mail Answers
Answer Posted / wukwai
It is unnecessary to insulate the cables because they are suspended in air and are supported by ceramic insulators at the supporting poles or structures.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
what is the transiant condition in alternator? and how it can be prevanted?
why we have and use 3 phase not 2 or 4 or other in power system?
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
Refernce currents are to be generated using refernce cueernts how can this be done??
Why Ac Systems Are Preferred Over Dc Systems?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
what is the saturation point of crgo lamination.
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
how to calculate the battery AH
What is difference between slip rings and carbon burushes?
What is the basis for framing the rules of block diagram reduction technique?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
