Interested to Buy Any Domain ? << Click Here >> for more details...
What is the lap length in your project?
- 11 Answers
- 21088 Views
- L&T, Practical Viva Questions, I also Faced
- E-Mail Answers
Answer Posted / yash kumar
lap length in tension as well as in compression zone it as standerdly taken max=50d,min-40d,d is dia of bar.and if there is welded joint preference lap is different
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Dear Sir What is the Contraction joint for base Slab
Hollow block masonry in cement mortar 1:4, 40×20×20cms in superstructure take 10sqm.I want calculation of brick sand
What does a construction cost covers and what does not?
What does civil engineering mean?
give me the mix proportion for design mix concrete M 7.5 grade 1:4:8
How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel
How many bricks are there in 100cft?
How many axes do cartesian coordinate system has?
PL.tell me about civil engineering questions with answer
what is the cost of rcc roof casting of 400 sq. ft. in kolkata
Rate analysis of Vitrified tile in cement mortor 1:3
Under what circumstances should pot bearings be used instead of elastomeric bearings?
strength of bitumen concrete with 80-100 & 60-70 grade bitumen
Describe a time when you anticipated potential problems and developed Preventive measures
I need to do a Compressive Strength Test for a specimen made of Rubber. Before doing the Test on the Machine, I need to have an idea of the Minimum and Maximum Compressive Strength or Yield Strength of the specimen. How can I calculate that?
