Can you explain drawbacks between P,I,D & PID controller
- 1 Answers
- 8870 Views
- JSW, Priya Cement, TPL, I also Faced
- E-Mail Answers
Answer Posted / koolfire
P,PID controller'S are used to tune the output to a desired value.
however for proportional controllers it always has a steady state error as the output will never reach the desired value but will be close to it.
For a PID controller due to its integral and derivative action(rate of change of error), it cancels out the steady state error.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
What is wet leg condition and why is it used?
what is the difference between profibus and controlnet networking.
What is PDS and PDMS ?
What is difference between radial vibration and axial vibration explain in detail .
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
How to calibrate level transmitter with use of HART?
please send data bank of quetions answers on analytical instrumentation.
What is eddy current? Describe the operating principle of proximity probe.
What is 1:1 redundancy ?
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
