What are the implications when the power factor is is
leading condition ?
- 1 Answers
- 2559 Views
- I also Faced
- E-Mail Answers
Answer Posted / n panja
power factor is in leading condition means the system is capacitive as in a capacitor current leads voltage. It also suggest that the system is running under low load or zero load condition. Excess reactive power may cause higher receiving end voltage than the sending end (ferranti effect).
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
explain the Trip supervision circuit
List examples of voltage source?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
List examples of current sources?
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
Pls mail me utility & Dg related question with answer
wat is d diffr btw shunt coil and trip coil in VCB?
How to calculat the ratio of HT\LT in energy meter
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
