Interested to Buy Any Domain ? << Click Here >> for more details...
what will be the efficiency off x'mer during no load test and during short circuit test
- 1 Answers
- 4137 Views
- GPSC Gujarat Public Service Commission, I also Faced
- E-Mail Answers
Post New Answer View All Answers
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
what is differnce btwen lll and lllg faults
what the Microsoft .NET framework is?
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
Why induction motor is widely used in industry
State the frequency for rc phase shift oscillator?
given data are load current & power factor cable core size? plz any one update the calculation formula
Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
The shot circuit in any winding of transformer result? Explain
describe the Tranformer testing procedure
Why Stabilising Resistor used in REF circuit ?
why we use circuit breakers for switching instead of normal switching device?
which type of stability limit is higher,steady state or transient? why?
