Interested to Buy Any Domain ? << Click Here >> for more details...
in 33/11kv stepdown transfomer, transformer will stepdown to 11kv & remaining 22kv where it will go..
- 3 Answers
- 6284 Views
- I also Faced
- E-Mail Answers
Answer Posted / narendradalai
The power & frequency both are constant in transformer.
V1/v2 equal to i2/i1.
V1i1 equal to v2i2
P1 equal to p2
So remaining convert into current.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
What consists of 2 or more thermocouples to be connented series?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
what is the total power generation in india?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
draw the block diagram of fire alarm?
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
I am inpecting a 10kVA UPS what tests should i do and should i observe?
what is sevice settings for mccb?How can be it setted?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
