why level transmitter input is given 4to20ma
- 2 Answers
- 5735 Views
- Sabic, I also Faced
- E-Mail Answers
Answer Posted / ayaz
Tranmitter input supply in voltage 24vdc and output 4-20 is standard output signal and use for Transmitter health monitor.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
What are different types of orifice plates? State their uses.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
what is the input of digital counter during the the calibration time?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
Please tell me details about Sox,Nox,SWAS analyser????
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
what is basic difference between motion balance and force balance in pneumatic instrument?
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
