Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vibhum bakshi
Plc- plc is a microprocessor/microcontroller based centralized controller which is devloped to perform sequential as well as discrete sequntial logic in industry environment for incresing productivity, redusing cost and incresing safty.
Rtu- rtu is stand for Remote telementry/terminal unit. It is microprocessor controlled electronic device that interface object in the physical world to a DCS or SCADA system by transmitting telementry data to a master system.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the areas where I need to make improvement? (Please provide examples and suggestions for improvement).
What’s the normal transformer current rating?
pls sir can any body tell me the important questions of power plat operatoe my id is ali.ind85@yahoo.com plss
Difference between chopper and dbr?
What is setup time?
Let’s say we live in a country that gets very cold, in Northern America / Europe. In winter, we monitor the ouside temperature, so that heaters can be switched on, inside the house. The idea is that, the colder it is outside, the warmer it should be inside. The heating side of things is just a heater that is either switched on, or switched off. Just from the information that has been given, please discuss this matter in depth. Provide reference to OPEN / CLOSED loop control, FEEDFORWARD / FEEDBACK control and MODULATING / ON_OFF control raised in the discussion.
what is alternater & engine genral protection?
What is alternator & engine general protection?
How capacitor bank can prove superior to synchronous condensers with respect to power factor correction?
Explain about fire hydrant and its related water pressures?
What is the difference between automotive production and mass-production.?
What causes little rust pockets to pop through or off concrete cylinder blocks (home)?
if salary paid per month rs. 16000/- of female <65 i will deduct tds from his salary please what i will do explain?
How the costs of the products and throughput time can be reduced while handling materials?
What are the various methods for calculating the cost?
