Interested to Buy Any Domain ? << Click Here >> for more details...
What are the Safety measures in central chiller plant?
Explain them?
- 22 Answers
- 67085 Views
- Carrier, CPIC, HSL, JLL, I also Faced
- E-Mail Answers
Answer Posted / vikesh kumar
1.High pressur
2.Low pressur
3.Oil pressur
4.Anti Frizer
5.Water Flow Switch
| Is This Answer Correct ? | 37 Yes | 3 No |
Post New Answer View All Answers
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
How to check the Bushings of the transformer?
What is corkscrew rule?
bsec exam syllabus (mis)
What do you mean by pull of electromagnet?
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
why should the primary of transformer be connected in delta in a heat run test?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
what is the solution for meger test failed the MV cable?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
