Interested to Buy Any Domain ? << Click Here >> for more details...
Dear,
How much ph is maintained of water electrolite used in lrs for slipring induction motor ?
- 1 Answers
- 3380 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Anyway more than 8 . Even 13 can be expected
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Dear all, i completed M.E(Power Electronics & Drives) 2011 passed out having 78% so i need job in core side but i don't know how can i receive the calls from electrical companies and i uploaded my CV in naukri, times jobs etc.. In that iam not recieved any mails from good companies so give me best procedure plzzzzzzzzzzzzzzzzzzzzzzzz..... Thanks, K.Linga Reddy Email-id:-lingareddykmthm@gmail.com Ph no:-08015402078
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
previous year paper of ntpc bhel for degree in electrical enng
how to read idmt curva
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
How to synchronization will be done between two DGs ?
why the NGR (neutral grounding resistor) always OFF during DG off?
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
What are high pass filter and low pass filter? and What are the flowmeter ?
what ispositive, negative, zero sequence impedence?
is it possible to test of bus bar in high rise building without completed full floor ?
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
