Interested to Buy Any Domain ? << Click Here >> for more details...
What is an analog input-output
- 10 Answers
- 62105 Views
- TN, Torrent Pharma, I also Faced
- E-Mail Answers
Answer Posted / veera
transmitter output are AI ,
control valve input are AO ,
all process variable switch are DI,
SOV and light on starts condition are DO,
| Is This Answer Correct ? | 20 Yes | 0 No |
Post New Answer View All Answers
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
what is the protection system in solar turbine compressor
What are different types of orifice plates? State their uses.
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
How many are the types of instrument cables in terms of No. of pair.
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
why fuse block is not used for AI signal?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
what can of fault ofently come in vibration mesurement?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
Explain why plc require in analog input 4-20amp & 0-10 volt?
What is the working principle of the magnetic meter?
Manipulation of dead wt. tester double piston type.
