Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ayaz
please re-read the question we don't know which type of control valve but when pneumatic control valve shall write in question then we wrote the answer
input is 4-20 ma
output pneumatic depending on control valve bench set for example 3-15 psi or 6-30 psi
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
how to relay switch sense the fault?
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Why grounding is necessary? Give example with diagram.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
line up procedure for dp type flow transmitter?
flow transmitter formula?
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
what is interface level and how it is calibrate?
what is the importance of CV in the control valves? how it is calculated?
what is intrinscily safe system and where we use?
What is the diffrence between ff tx and non ff tx
why using negative supply for bentley nevada vibration system ?
