Answer Posted / richard

Because the field across the conductor in EHV is higher than Hv, so the ground clearance on EHV must be higher to ensure efficient voltage transmission,safety of life and property.

What is miller crystal oscillator? Explain its operation?

1116

---

Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above

2225

---

how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?

2266

---

How is operate breaker failure scheme in substation

2123

---

1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?

2519

---

how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?

2649

---

how to find the capacitance value of the motor while running??

1938

---

how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids

1903

---

How to calculate the fuse rating depend upon the DC circuit?

2869

---

what is a types of short circuit and what is a types of distance protection tests

2262

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

1874

---

what is advertised hop count

1775

---

solar inverters was not connected to the nuteral link .this nutwral possible to any other systems

1887

---

What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?

1903

---

what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?

2015

---