Answer Posted / kk sharma
mix of concrete.it represent the compressive stength of concrete.
M20-1(cement):1.5(sand):3(aggregate)
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
What is the use of array command?
where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?
Dear Sir What is the Contraction joint for base Slab
Does degree of bend of rebars has any effect on strength of the member? For example- if a beam is designed with 45 degree bent up bar with respect to architechtural needs and is not 45 in practical so will there be any reduction in the strength of member?
where tie beam is used? what is the pupose? what dimension of tie beam can provided and number and diameter of steel bars to be used between the columns of 1333mm and 1400.
What is an object snap mode?
What is Joule Brayton Cycle?
What is the use of mirror command?
Under what circumstances should pot bearings be used instead of elastomeric bearings?
i am completed my b.tech EEE in 2009,,,iam trying the job 3+ for AUTO CAD (ELECTRICAL),, what is the market for autocad electrical in hyderabad... how to handle the intervws give some suggestions ?
If we buy crush sand for 3200/ Brass and cement for Rs350 /Bag and flyash 1200 / tonne....and my production is 230 Bricks per bag than how much cost is required for 1 flyash brick?
Explain the Strength of brick?
what is the procedure involved in preparing mix design of m15 grade as per IS-10262-1982
Why are pull-out tests performed for soil nails?
What is the use of water table & Kreb stone for drain
