Interested to Buy Any Domain ? << Click Here >> for more details...
why use only sf6 circuit breker in 400 kv sub station
- 5 Answers
- 8759 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / eedeepak
sf6 is the best material till now because it's ability to extinguish arc
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
Do closed loops systems require manual input?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what happen when increase or decrease size of lamp,light.glass.
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
While testing LA mast,What are the parameter limits ?
Tell me about ur past electrical maintanence job
Explain the working of variable frequency transformer?
What are your future plans for the company if permanently employed?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
