Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / eedeepak
the rate of flow of charge
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Can any body tell gulf interview question for experienced electrical engineer ?
differnce between single acting and double acting solenoid valves
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
What is meant by stator?
why the name trunking bus PT
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
What is principle of Floroscent tube 36watt.
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
Briefly describe your ideal job?
What current position are you holding in your current company?
