Interested to Buy Any Domain ? << Click Here >> for more details...
what is the mean of short circuuit current ( for ex. 50KA)?
- 2 Answers
- 5812 Views
- Weltech Engineering, I also Faced
- E-Mail Answers
Answer Posted / b495
It is the maximum fault current, which will flow through the system at the particular point in the system, while there is a 3-phase fault in the system.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What are the conditions to be satisfied for parallel operation of dc generators?
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
what is the cause of voltage dipp or swell in the transmission lines?
application s to shunt coil
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
how cables go in and come out for distribution from the feeder pillar box?
what is spadar bar .why I use in DC generator.
compare between starting charactristics of synchronous motor with those of 3Q Squirrel cage induction motor
What aturn on methods of scr?
a governer in an Ic engine controls the
what are factors to be consider in electrical installation like load factor,diversity factor .....
how does a submersible pump work..?
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
