Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mohamed rafik
The opening or closing of control valves is usually done automatically by electrical, hydraulic or pneumatic actuators. Positioners are used to control the opening or closing of the actuator based on electric, or pneumatic signals.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is the calibration procedure for magnetic flow meter @ onsite
Explain signal isolator
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
What is the difference between mmwc and mmwg?
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
Explain the working of rota meter.
how u calibrate pneumatic n motorized c/v?
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
how is work pressure switch& level switch?what is the principle of this?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
What is difference between Ionization heat and bimetallic heat
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
How hart protocol can be connected with control valves?
