What will happen if 2 phase supply is given to 3 phase
motor?
- 4 Answers
- 6106 Views
- ABC, I also Faced
- E-Mail Answers
Answer Posted / koti1965
It will not start at all but draws more current and trips on locked rotor protection failing which it burns.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
how to select the isolation tranformer for siemens 802dsl cnotroller
where we use the SFU & FSU?
explain with diagram how to protect transformers and substations from over current with help of CT's?
how we decide the require size is this for a known current at fuu load?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
What is MSL designation of a motor and same may be provided in details.
how to protect motor in dol starter having capacity of 30 hp.40 hp?
What is the difference between voltages or potential difference? And what are they?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
Why is water motor not taking the pressure? what is the problem?
Iin ESP why positive is grounded ? why not negative ?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
how are reversing the direction of rotation of dc motor
