as per IE stranded what is max voltage between neutral to
earth. 100 kva transformer neutral solid earth.
min and max values i need to ans for RTI question
- 2 Answers
- 3796 Views
- I also Faced
- E-Mail Answers
Answer Posted / salim mullani
1.5 ohm to 5 ohm
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
Why armature rheostat is kept in maximum position?
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
please give me solution to rectify the emi(electromagnetic interference)
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
send me any model test paper of clerical post of state bank of india.......
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
Y phase plates are used in transmission line??? what is there need???
How would your past experience translate into success in this job?
List the disadvantages of constant k filters?
XYZ
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to extend relay operating timing in 24V dc relay card (without using Timer )
How many gap between finger contact in a.c.b. and v.cb.?
what may the reason for vector shift in a generator?
