Interested to Buy Any Domain ? << Click Here >> for more details...
why we usually call 415 volts instead of 440 volts
- 3 Answers
- 8316 Views
- S Tech, I also Faced
- E-Mail Answers
Answer Posted / rawat
For 230v single phase, 3phase will be 440v and for 240v the 3- phase will be 415v.
| Is This Answer Correct ? | 6 Yes | 13 No |
Post New Answer View All Answers
what is transient voltage?
What is measurement?
What is stepper motor. What is its uses?
What is the difference between line drop and percentage line drop?
What is Anemometer used to measure?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
How can find thermal state value in relay for calculate thermal overload.
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
how to select rating of HT Panel
how to select the double earth conductor if 21A full load?
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
How to choose the vector group for the step up and step down transformers??? Tell me the which vector group is suitable for step up and step down transformers and whats the reason to choose and whats the benefits???
