Answer Posted / rodel baluyot
LOOP CHECKING IS CHECKING 4 TO 20 MA OUTPUT FIELD AND CONTROL ROOOM
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
how to commission furnace ( water heater)
What is modbus?
Decibel.
Can anyone send most commonly asked interview question in Oil & Gas industry
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
can u briefly explain aboutan aryton shunt multirange DC ammeter?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
what is the input to be given in digital flow meter during the the calibration time?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
What is the difference between PLC and DDC?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
How to Calibrate Radar Level Transmitter in Field
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
