Interested to Buy Any Domain ? << Click Here >> for more details...
Can i convert 230v ac to 24v dc by using a relay?Instead of
Smps is it possible?
What is relay logic in plc ??
How it works?
- 2 Answers
- 11700 Views
- Infotech, I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
A DC power supply converts it input, AC line voltage to a
regulated DC voltage output.
A relay coil can be driven by one voltage and its contacts
can operate at a different voltage so a relay coil could
operate at 230Vac, with its contacts switching 24Vdc. But
that's not 'converting' AC to DC; the relay itself requires
that those voltages be supplied to it, it can not 'convert'
AC voltage to DC voltage.
There are linear power supplies and switch mode power
supplies (SMPS).
Relay logic is the name for the use system logic consisting
of discrete relays, switches, timers and counters which are
wired point to point.
Ladder logic is the symbolic representation of the same
elements used in relay logic: relay coils for inputs, relay
contacts for outputs, contacts for switches, timers and
counters in PLC programming.
The ladder representation looks like a ladder with rails and
rungs. The rails are line power rails, the rungs have the
logic elements in parallel or series as needed.
Carl Ellis
Measure First
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
what is the input of digital counter during the the calibration time?
Identification of ss fittings, pilot valves, relief valve.
Any body have know try work calculation ???
what are the steps I have to deal with?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
what is compensation? temprature & pressure
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
State bernoulli’s application.
which processor is used in dcs.
How to find out the current of two motors having same power consumption but different RPM?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
What is offset in a control system.
What is stripper & spilitter ? Diffrence in this.?
