Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raman jain
How much current your equipment draws when running on full
load.
Then decide the de-rating factor.
Then table will tell you the size of the conductor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is MSL designation of a motor and same may be provided in details.
why should the primary of transformer be connected in delta in a heat run test?
Can an inverter be used as a converter? How?
what is the difference between circular wdg & ractangular wdg?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
can we use NPT glands in LT panel
What is step signal?
operation of diesel generator
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
What is the physical significance of phase.. i.e. what is exactly the meaning in layman's language.. 1 phase, 3 phase etc ???
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
