why the generating voltage in India is 11kV or why is it be
transmitted as multiples of 11
- 34 Answers
- 113251 Views
- ACC, Bhel, ECI Engineering and Construction, NTPC, SBL, Senthur Power Services, I also Faced
- E-Mail Answers
Answer Posted / pritam kumar(gges)
now a day transmission line consumed 4 to 6% of the total power...
But in early days it consumed arround 10% of the total power,and formfactor value is 1.11.so generated voltage design as multiples of 11.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is called limb of a transformer?
How to find ampere on ht side for selection of cable size ???
Who are the manufactures those manufacturing 3Cx2.5sqmm FRLS cables. I heard about FRLS technology adopted only in wires useful for wirings
How out of step protection relay works?
How to calculate ant test the burden of Current transformer
Is Transol transformer oil comparable to nynas nytro libra?
What determines the thickness of the lamination or stamping?
How to select the proper VSD to operate high inertial load
tell me about eletrical contractor
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
Can a generator runs after getting 1st stator earth fault.
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
Difference between a pilot wire and a normal conductor?
