Interested to Buy Any Domain ? << Click Here >> for more details...
How we can measure the thickness of bus bar for a given load
? any farmula Plz elaborate clearly.
- 2 Answers
- 7740 Views
- ITC Infotech, TCS, I also Faced
- E-Mail Answers
Answer Posted / mostafaghodrat
First, we calculate the load current
Second, consider the highest temperature and selection
coefficients associated to it. For example: 50C
Third, the rate of sea level and the corresponding
coefficients, for example. For: 2000 meters
Fourth, the relative humidity is considered, and find the
coefficients. For example: 25G / M3
Coefficients are included in the tables.
I do not know how to put an image
If i learn how to put images on your site
Be sure to leave
I'm from Iran and my English is not good
Excuse me the my English is not good.
good luck.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
which type of stability limit is higher,steady state or transient? why?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
What is negative sequence over voltage element?
How to operate a ac chilar plant?
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
How are load losses and no-load losses measured at site in a DG set?
The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is
Explain Even and Odd signals?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
How to calculate or formula to calculate rhe power in 2 phase system ??
