why the backwheel of tractor is bigger than frontwheel?
- 12 Answers
- 14739 Views
- HAL, HMT, MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / bishu
1)Since driving wheel in Tractor is in rear wheel and driven
wheel is in front. If driving wheel(i.e,rear wheel) rotate
for one time then driven wheel(i.e,front wheel) rotate more
than one time because of it smaller size.. As the rotation
increases in front and rotation decreases in rear lead to
more velocity ratio....... TO INCREASE VELOCITY RATIO IN
TRACTOR BACKWHEEL IS BIGGER THEN FRONTWHEEL
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have just joined mechanical engineering this year. I just wanted to know the names of the books which would improve my engineering knowledge and skills. Or isthere any other means to improve it?
After any cause of repaired how i start the engine by slow speed 800 to 900 rpm electronic control moudle engine [cummins]
8000 Liter Water in 80 degree Celsius will generated how many STEAM ?
What are the different types of pumps? and their usage.
Explain the difference between mill and mill-drill?
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
What is the function of mouth ring
what is the difference between under vacuum & under pressure boiling?
I am Sunny..I have completed B.Tech(Mechanical).can i apply for Probationary Officer Post in Syndicate Bank 2010.Is that they hire engineers for PO Post?
How much stack emmission through your chimney and what is the state govt norms ?
how many types of suspensions are used in automobiles?
Function of nozzle holden
We have 6-axis wotan horizontal milling & boring machine. Linear axis- x,y,z,w & U. Rotary table B Axis Z,U & W axis are parallel. Z is tool axis. X is cross slide. We wish to retrofit the machine.Which control I should select & also suggest How many axis simutaneous control for linear & circular interpolation.
Why an increase in area is required to produce an increase of velocity in case of supersonic flow ?
why not a.c supply used to charged the lead acid battery
