Interested to Buy Any Domain ? << Click Here >> for more details...
In which connection the voltage will be more , in star or
delta connected motor?
- 3 Answers
- 6829 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohammed rafi
all aforesaid answers are absurd or partially mistake.
Both delta connection and star connection has same voltage.
But star connection gives the provision to tap a separate single phase connection which will be of course lower voltage.
For example- In India,existing 3 Phase supply is 415V (10% deflection is permitted). You can obtain it either in the form of delta connection or star connection.
The single phase connection (230 V)which you receive in your home is actually a taped connection taken from star connection. A star connection will have 4 wires,there are R phase,Y Phase, B Phase and Neutral. Voltage between R-Y and R-B and Y-B or any phase to phase combination is 415 V
Now if you take a phase,let it be R or Y or B and check it's voltage w.r.t neutral,it will be 230 V. This is known as single phase voltage.
Delta connection has only 3 wires,they're R,Y,B and there is no neutral. So You cant tap a single phase from a delta connection directly.
This is the difference between star and delta connections. Moreover its worth to mention that question which triggered all these discussion is wrong. Because,now you have understood both has same voltage but the only difference is you can tap a single phase connection from a star connected supply.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Define end float in a motor?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2
What is the universal motor?
at which voltage level arcing ground is occurs ??????????
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
is it possible to test of bus bar in high rise building without completed full floor ?
explain the mode of metal iranafer in Co,welding
What is the principal of motor?
Classify drilling machines.
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
How could a garment factory benefit from renewable energy
why the active power flow of some line is increased when the active power of out is cut ?
