why nearly all the voltage levels are in the multiples of 11
like 3.3 ,6.6 ,33 ,11 kv.....
Answer Posted / e.subash chandrasekar
Because of form factor 1.1
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is RFID? thire application;
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
how will we calculate the copper wire load..
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
Is RTCC panel needs any control supply.
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
How can we findout the maximum efficiancy of Transformer? At which load?
What are the types of transformers according to the arrangement of iron cores?
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
why industry prefer ht motor instead of lt motor.
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
star delta starter contorl circuit... drawing..
If any cable burnt how can we identify it burnt by high current of high voltage?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?