Interested to Buy Any Domain ? << Click Here >> for more details...
what is the physical phenomenon because of which skin
effect occurs ??
- 6 Answers
- 11174 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / asar
ll electric currents generate magnetic fields that in turn
can affect the current (this is the principle behind
electric guitar pickups). In a direct current case
everything is constant and so nothing seems to happen. With
an alternating current, however, there is a delay in the
magnetic field's response to the change in current and the
'old' magnetic field tends to push the current towards the
outside of the conductor. As the frequency increases, so
does the effect until at very high frequencies the entire
current flows in a very narrow skin on the conductor--hence
the name.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is accuracy ? in any meters , coils accuracy . how can u defined that ?
What is the maximum percentage voltage drop (vd%)for a motor control center
how freewheeling diode improves the powerfactor
Why 3 phase induction motor getting supply in body if one of it's phase is cut
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Can you explain about Restricited earth fault protection scheme
State the factors, for the choice of electrical system for an aero turbine.
What is a system?
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
What is the reason that the humming sound is coming from the induction furnace panel?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
What is the disadvantage in proportional controller?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
