During shutdown of Steam Turbine,How do we cross the
critical speed?
Answer Posted / chanchal rajput
As we closed esv after that speed of the turbine goes to
slow down automatically we can not any thing as it cross the
critical speed , for short time vibration increase but after
that goes slow down and turbine stop .Some turbine run above
the critical speed and some below the critical speed .
Is This Answer Correct ? | 0 Yes | 10 No |
Post New Answer View All Answers
LAPT working in alternator / generator
By any way can we increase the B check hours from 300 to 500
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
what is natural frequency of turbine shaft .
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
why airtel use + 24 volts and other operators use -48 volt
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
why do you consider yourself a suitable candidate for this position
what is the basic use of power plant in equipment
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
what's the moog valve
What is difference between secondary Air & Tertiary Air and Their use.?
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.