Interested to Buy Any Domain ? << Click Here >> for more details...
What happen if in three phase 440 v , when you check voltage
by testor it glows except one phase and in the same time when
you check by multimeter it shows 440 v in any two phase.what
will be the reason...
- 1 Answers
- 3547 Views
- Greatship, I also Faced
- E-Mail Answers
Answer Posted / ajitav nayak
As we know in 3-phase 4-wire ckt three phase R,Y,B & N respectively if we check with tester it will glow three phase except neutral.If we check with multimeter Phase to neutral it will show 230v & phase to phase 440v .But we cannot check all three terminal at one time by multimeter that is why in three phase we take 440V for calculation.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is RFCT and Insulgard Relay & It's function?
What is depreciation factor?
How line capacitance & line inductance varies with increase in height tower.
What is Auto Mains Failure Panel & Auto Synchronizing Panel
how a flip flop can be used as a latch?
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
explanation of mesh bus bars
static chagre
Define peak time.
where the lexical paramater will use in fron end?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
what is the ms flat constant for calculating earth mat design calculation?
