Answer Posted / pradeep kumar

Wake frequency calculation is used for determining the
accuate lenght of thermowell.

TEMPERATURE VARIATION FOR FREQUENTLY.

1981

---

if in a level tx height is given, how u calculate the ranges of the tx?

7571

---

How d.p. Transmitter can be applied to close tank?

966

---

Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,

1627

---

what is the criteria to decide conductor size of a cable ?

1814

---

hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v

2162

---

need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate

1265

---

what is wave length were using ?

1837

---

What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?

2441

---

What is 3 element control system

1436

---

What is the start up procedure of desalter

3612

---

what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??

3945

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

1611

---

How flow can be measured with dp?

1080

---

what is actual drum level and compensated drum level?

2175

---