Interested to Buy Any Domain ? << Click Here >> for more details...
what is the diffrence between mmwc and kg/cm2 for pressure
measurment when we are using mmwc and when kg/cm2 and why?????
?? what is the reason
- 19 Answers
- 204581 Views
- Ecoboard, Jindal, Sepco, I also Faced
- E-Mail Answers
Answer Posted / rajeev tyagii
MMWC (MILIMETR WATER COLOUM)IS A LOW PRESSURE MEASURING UNIT USE FOR LOW MEASURING AS GAS FLOW ETC AND ONE KG =10,000 MMWC.
MOSTLY USE IT INTO SAMPLE FLOW OF GASES IN ANALYSER AND FLOWMETER AND PREESURE SETTING of pressure switch also.
| Is This Answer Correct ? | 18 Yes | 4 No |
Post New Answer View All Answers
What is intrinsic safety mean.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
I need to know steps to Calibration Valve Guard......
What is eddy current? Describe the operating principle of proximity probe.
What are the interlocks we have to check during the start up of LP/HP compressor?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
why we are using drum level control valve air to close?
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
What is shielding effect?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
how to relay switch sense the fault?
In apron feeder how TPH is calculated?
How is PH sensor works ?
