Interested to Buy Any Domain ? << Click Here >> for more details...
What do you mean by Transformer?
- 9 Answers
- 16025 Views
- Hyundai, NTPC, wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / arunkumar.r
Transformer is a static device,
transformer works on mutual inductance principle only
operating in a Alternating Current then load connect the SEC
side connected PRI side connect the generating side
transformer convert to the one level to other level voltage
level with out change in frequency
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
what is the minimum voltage require to injure our body?
Instrument connected to a single phase supply
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
What happen Grid EARTH plat got cut.
can someone explain that how the speed of the protection system affects the fault level calculation?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
I am a possesor of c licence from 1993. I forgot to renew during the year 1998. During that time I was working at TNEB to till date. Is there any possibility to get renewed? or to apply for a new one?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
What is dc current source? Differentiate between ideal and non ideal current sources?
What is mean 2XWY
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
I am inpecting a 10kVA UPS what tests should i do and should i observe?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
what is tri state logic gate
