Interested to Buy Any Domain ? << Click Here >> for more details...
what is electric motorised valve working principle.
- 1 Answers
- 13055 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahipal
A electrical motorize valve is a valve that use an electric motor to open or close its mechanism. Commonly used type are gate, ball and butterfly,
| Is This Answer Correct ? | 24 Yes | 4 No |
Post New Answer View All Answers
There are many type of control cable like pair,core,tried, What are defination each one
What is 3 selection available when configure the burnout protection for controller
use of split range ? where it is used ? in which control loop it is used ?
What is the main difference between Cavitation and Flashing?
How many interlocks at turbine? Plz explain briefly
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
What is profibus?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
how to calibrate Necleuonic level transmitter.?
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
What is instrumentation technologists and mechanics?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
