Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / papu
• Keep to standard engineering rules in planning the use
of and operating the device!
• Installation and intervention for maintenance work are
only allowed by qualified personnel using suitable tools!
• Observe the current regulations on accident prevention
and safety for electrical devices during operation and
mainte-nance of the device!
• Before interfering with the system, always switch off the
voltage!
• Note that in systems under pressure, piping and valves
may not be loosened!
• Take suitable precautions to prevent inadvertent
operation or damage by unauthorized action!
• After interruption of the electrical or pneumatic supply,
make sure the process is restarted in a well-defined,
controlled manner!
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the difference between ff transmitter and non ff transmitter
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What is the difference between modbus,fieldbus & profibus
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
Explain pH, Conductivity.
What is zener diode? What is voltage regulator?
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
Valve positioner and actuators in detail.
What is eddy current? Describe the operating principle of proximity probe.
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
