how must steel will use for 1 cubic meter.formula of steel
for beam,column,lantern.
- 17 Answers
- 167333 Views
- CCCL, Gulf Construction, KITECH, L&T, Mars Planning Engineering Services, NHAI, Simplex, Supertech, Yamaha, I also Faced
- E-Mail Answers
Answer Posted / ram punnam
For Footing & Pedastral 1-1.5% of Volume of Concrete
For Columns 2-2.5% of Volume of Concrete
For plinth beam 1.5%-2% of Volume of Concrete
For Roof Beam 2-2.5% of Volume of Concrete
For roof slab 1-1.5% of Volume of Concrete
For RCC Road 0.5-1% of Volume of Concrete
| Is This Answer Correct ? | 26 Yes | 14 No |
Post New Answer View All Answers
what is the minimum compressive strength of clay brick
In block work seawalls what is the purpose of slip joints?
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
How to Rectify deep crack formed on Brick Wall? Explain the method of rectify the defect?
how much to get of BRC lapping in full yield and half yield ?
what are the Task work of different labour.?
give me the mix proportion for design mix concrete M 7.5 grade 1:4:8
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
factory shed foundation l=4, b=3' d=8' rcc foudation for top to bottom pl tell me cement ,steel ,sand ,labour cost ,excavtion,soil is weak not so hard
in plate load test what is the thickness of plate 20mm 5mm 50mm none
How to build the floor to ceiling bookcase?
What is the tensile strength of marble?
Define angular dimension?
What is meaning of Canceled/Flat Beam. What is difference between them? Both type of beam can bear same load if size (width)of the flat beam is increases and depth is same as slab thickness? Kindly suggest to me.
