For 132 KV line, PT or CVT which is prefered for measuring
& protection? is there any IS or IEE standard available?
Answer Posted / k.prakashchandra
For both protection and accurate measurement PT is used with
separate cores . For protection and apprx measurement CVT
is used
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
what is metering cum synchronizing panel and how it is used?
what is the reqirred voltage in HT motor to get full RPM on no load test?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
what is fault level of power system ?
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
what is the difference between neutral and earth
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
how to calculate single phase motor efficiency ?
Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer
How can I calculate ISF of current transformer?
what is the difference between pvc & fiber glass cables
Why does inductive loads consume KVARs?