Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kalkode sridher
Quality controle is a department in manufacturing units, where the analysis of product takes place to moniter the quality of product
as per the written procedures ,to inline with the customers and regulatory requirements
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
In HPLC calibration, caffeine is used as primary standard for wave length calibration due to caffeine is having dual maxima at 273 & 205 nm and one minima at 245 nm. Any body can give reference of these details from any pharmacopeia (with chapter no.) or any other authentic guideline?
Which parameter require to do for analytical method equivalency?
Why acetonitrile and water are used as extraction solvent when analysis melamine? I thought they are miscible and won't be able to separate...
What is the formula to determine the concentration of M of a solution given the % transmittance? Use %T = 43.7 as an example.
How to do regeneration of Metacarb Pb plus column?
why cone formation during dissolution?
How to calculate coreletion coefficient
if your impurity coeluting with each other in that situation how require to set specification? is it acceptable?
how much mass should be there in volumetric flask while in preparation of sample for assay?
Why sometime potassium ortho phosphate mix with acetone use for sample preparation for hplc
how to calculate elemental impurities?
[3/28, 20:52] Manoj P Venkatpurwar: how many impurities require to inject in assay specificity that how we can find out? and in Rs also how?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
How to establish relative response factor for hplc. Why it is required?
How do we fix the sample concentaryion in hplc method development. What is the basis?
