HOW MUCH MAXIMUM CURRENT TAKEN BY NEAUTRAL IN 125 KVA DG SET
Answer Posted / k.prakashchandra
20% of the rated current as the EFR is at 20%. Neutral
current should be avoided as far as possible .
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
neutral earth resistance testing is it possible for transformer while in load condition
how can motor both beasrings insulation resistance can be check?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
What is the difference between diode and a transistor in terms of the direction of current flow?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
diff.between servo motor and ac motor
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
how we findout a ignater is faulty or not?
The moisture in air will condense at