What is main difference between
earthing and neutral grounding?
Answer Posted / 7anoter4
See:
http://control.com/thread/1026202024
Posted by Bob Peterson on 20 October, 2004 - 11:41 pm
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
What is the earth treantment procedure?
what is allowable ac mixing in dc
What are the different towers used in 132kv transmission line? what are the differences between the P,R,S towers used in 132KV and detailed explanation
what is the effect of un-synchronized power.
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What is the classification of hydro projects based on installed capacity?
Why star delta starter is preferred with induction motor?
How to calculate earth wire load by formula
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
difference bewteen reverse current and alternating current
for compensate 315mh inductance ,how many capaciance required?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate